Factory Defaulting My Honeywell Lyric Controller
If your Lyric controller has previously been registered with AlarmNet unfortunately a factory default (reset) is required when changing AlarmNet dealers. This clears all user codes, sensors, you name it – back to a brand new out of the box Lyric controller. Follow the steps below to default the panel so you can get registered again with AlarmNet but at a much lower affordable price with SafeHomeCentral.com. We can assist with reenrolling your wireless sensors remotely after we get you online with AlarmNet either via WIFI, cellular, or both.
Honeywell Lyric Controller (LCP500-L)
Factory Default
- Press Home
- Press Security
- Press Tools
- Enter your Installer Code (default is 4112 unless changed)
- Press Program
- Press Default Configuration
- Press Yes you are sure. There will be no message saying the reset was successful.
- Press the Back Arrow until you reach the main screen or press Home to exit
Soft Reboot
- Press Home
- Press Security
- Press Tools
- Enter your Master Code
- Press Advanced
- Press Reboot
- At the “Are You Sure” prompt press Yes
- You will see “Panel is rebooting. Please wait.”
- Press the Back Arrow until you reach the main screen or press Home to exit
Hard Reboot
- Remove bottom screw
- Remove Lyric Controller from wall
- Unplug backup battery from motherboard
- Unplug transformer at 120VAC outlet.
- Wait ten seconds then plug battery in then backup battery.
- Lyric Controller will begin to bootup (will take a few minutes).
