Programming Wireless Sensors Into An Interlogix Concord 4

Security sensors, especially wireless,  must be enrolled locally on an Interlogix Concord 4 keypad.

An alpha-numeric keypad is required for programming.

 

Key	Function
#	Select item (Enter)
*	Go back one tier (Escape or exit)
A	Scroll up within the menu
B	Scroll down within the menu
C	Insert pause when entering phone numbers
D	Delete (where applicable)
1	Off (where applicable)
2	On (where applicable)

Programming

To enter programming mode on the keypad:

1. Press [8] .
2. Enter the installer code (default is 4321).
3. Press [00] for the command. The screen displays System Programming .
4. Press [#] to enter programming mode.

To exit programming mode on the keypad:

1. Press [*] until the keypad displays System Programming .
2. Press [A] and the screen displays Exit Programming . The Ready light blinks.
3. Press [#] and the display returns to the time and date.

 

To enroll sensors using the keypad:

• Press [8].
• Enter the Installer Code.
• Press [00] for the command. The screen displays System Programming.
• Press [#] to enter programming mode.
• Scroll to Sensors, then press [#] to select.
• Scroll to Learn Sensors, then press [#] to select.
• Enter the sensor partition number, then press [#]. This is generally “1” for partition one.
• Enter the sensor group number, then press [#].
  • Instant Perimeter Zone = 13
  • Normal Exit/Entry Delay Zone = 10
  • Motion Detector Zone = 17
  • Smoke/Heat Zone = 26
  • Freeze Zone = 29
  • Carbon Monoxide Zone = 34
  • Flood Sensor Zone = 38
• Manually tamper the sensor to be recognized by the panel. Take the cover off of the transmitter to cause a Tamper

To remove sensors using the keypad:

1. Press [8] .
2. Enter the installer code.
3. Press [00] for the command. The screen displays System Programming .
4. Press [#] to enter programming mode.
5. Scroll to Sensors , then press [#] to select.
6. Scroll to Delete Sensors , then press [#] to select.
7. Scroll to the sensor to remove, then press [#] to remove the selected sensor. The screen displays Done when a sensor is successfully removed.
8. Continue to remove any other sensors, or exit programming.